Been iterating a bit on my revxlp design, and a frequent request is for a 10u/“5 col” version.

Finally did a build of the first protos, and it’s working great! I want to do a few tweaks for the newly added ability to use the single color LEDs for either per -key or bottom backlighting, once that’s done I’ll formally release the changes.

This particular build was half soldered by our elder daughter, and she fully assembled post-soldering including keycap selection. I love the look she chose, which she said “reminded her of a sunset over the water”

  • 10u revxlp
  • XIAO RP2040 running ZMK
  • Keycaps:
    • MBK: dyes from MKU and factory dyes from LowProKB
    • Asymplex convex 1u artisans for the bottom row
  • Choc whites
  • MJF nylon case print from JLC
  • petejohanson@lemmy.worldOP
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    Sorry about that. Fixed!

    Let me double check the PCBA files… I didn’t get the 10u protos assembled, but they should be fine.

    • hansamann (he/him)@lemmy.world
      link
      fedilink
      arrow-up
      2
      ·
      1 year ago

      Awesome, you deserve thx so much. I will try again soon as some of the components are not available, indeed. Would be nice to get it assembled fully.

      • petejohanson@lemmy.worldOP
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        Do remember that even with assembly on the bottom, you still need to solder the controller sockets, pogos, and battery connector.