Been iterating a bit on my revxlp design, and a frequent request is for a 10u/“5 col” version.

Finally did a build of the first protos, and it’s working great! I want to do a few tweaks for the newly added ability to use the single color LEDs for either per -key or bottom backlighting, once that’s done I’ll formally release the changes.

This particular build was half soldered by our elder daughter, and she fully assembled post-soldering including keycap selection. I love the look she chose, which she said “reminded her of a sunset over the water”

  • 10u revxlp
  • XIAO RP2040 running ZMK
  • Keycaps:
    • MBK: dyes from MKU and factory dyes from LowProKB
    • Asymplex convex 1u artisans for the bottom row
  • Choc whites
  • MJF nylon case print from JLC
  • petejohanson@lemmy.worldOP
    link
    fedilink
    arrow-up
    2
    ·
    1 year ago

    Do remember that even with assembly on the bottom, you still need to solder the controller sockets, pogos, and battery connector.