3D-printed this Key Organizer. It also holds an Apple AirTag. Not completely my design, I redesigned an existing model to better fit my needs. I also stamped my name into the back of it (only in my personal version).
If someone owns a 3D-printer and is interested, the files are available here for free:
https://www.printables.com/de/model/530841-remixed-keytag-key-organizer-m3-attachment-loop
No, just placed them beside each other and adjusted the tension by tightening a bit. These two keys are fairly level and don’t seem to snag each other.
On the other end, I attached a key ring (that connects the magnets and the way-too-large car key).
Ah okay, I am used to my old not so level keys, so I placed some washers between them to prevent them from getting stuck.