Or at least, a side table. What is the process of doing that? I have basic hand tool for working on some other small project, a small circular saw(that attached to a marble cutter), and an electric planer, what else would i need?
Or at least, a side table. What is the process of doing that? I have basic hand tool for working on some other small project, a small circular saw(that attached to a marble cutter), and an electric planer, what else would i need?
By electric planer, do you mean a handheld planer, or a pass through planer? If you mean the pass through kind, then that’s probably fine, but you might have a problem with it taking chunks off the edges, due to the orientation of the grain.
If you are just doing a single slab, building and setting up a router sled is more work than doing it with a hand plane, manual or electric. So I would go that route if possible.
That being said, it’s going to crack as it dries unless you cut it before it starts shrinking.
Hand electric planer like the other user posted.
Where should i cut it to prevent that?