I mainly want to get a coffee grinder because beans have a longer shelf life and are cheaper. If I also get better coffee, that’s a bonus! (Basically, I’m not looking for a premium option)

What is something I should pay attention to when buying a grinder. I see people mention “flat burr” grinders all the time. Is that something important?

A few years ago I bought a cheap terrible manual coffee grinder off Amazon. It took 5-10mins to grind my coffee. The grounds where too course and my hands hurt. Is the experience better with higher quality manual grinders? At the moment, I’m not a huge fan of manual grinders because of this experience and am leaning towards buying an electrical one.

What makes a coffee grinder better than others? What is the difference between premium and budget options?

  • DahGangalang
    link
    fedilink
    arrow-up
    2
    ·
    10 months ago

    Attempting to ask similar question:

    I do cold brew but haven’t found a grinder that give a consistent grind that’s coarse enough.

    My current method is to grind as coarse as I can, and then run through a fine mesh sieve. Even then, I end up with a good amount of grounds making it through the mesh container I use for soaking.

    Is there a go-to grinder people like for cold brewing?

    • joemo@lemmy.sdf.org
      link
      fedilink
      arrow-up
      2
      ·
      10 months ago

      If you don’t want to buy a new grinder, you could try running the coffee through a coffee filter afterwards. So you grind the beans, let it soak for however long, and then run the coffee through a coffee filter. I use a Chemex to make coffee sometimes, so I use that but anything will work. I’ve put a filter in a funnel and used that.

      This will catch the sediment, in my experience it has taken a while to filter through.

    • WHYAREWEALLCAPS@kbin.social
      link
      fedilink
      arrow-up
      2
      ·
      10 months ago

      Have you tried grinding at a medium grind instead of coarse? There was a video posted here of someone that did a test between grinds and found that the medium grind had the best results. You could try a small batch and see how it goes. Also, instead of sieving before steeping, try running it through a filter after steeping. You could get a cheap pourover to run it through. Alternatively, look on Amazon for filter fabric that’s down to like 2 microns or less like these - https://www.amazon.com/Pack-Micron-Filter-Short-Socks/dp/B09SY6DKD8