As they say, a good start is half the battle

https://archive.is/www.economist.com/finance-and-economics/2024/10/03/a-tonne-of-public-debt-is-never-made-public

Yea you are? Sprinters or Crafters easily fit a stack of sheets, at least in the EU they do

deleted by creator

http://jellykey.com/

• touch the tip of the solder where the iron meets the pad or the pin

• try to get as much contact with both the pad as the pin as you can

• the pad could be dirty or not hot enough. Especially when the pad is connected to a ground or power plane layer in the PCB it may take longer than expected to reach a sufficient temperature. Usually adding some flux helps remove any dirt.

Thanks for the update and your hard work!

Did something change? Last time I bought an album on Qobuz i could download the whole thing in a single zip file. This was quite a while ago though