Part-time practitioner of pixel purveyorship. Sometimes ships software.

  • 0 Posts
  • 13 Comments
Joined 1 year ago
cake
Cake day: June 29th, 2023

help-circle
  • I got PETG working on my Mini clone by basically just switching to 0.6 nozzle profiles from the wizard and using the generic PETG profile.

    But, if you’re new to PETG, know that it gets real moisture sensitive, real fast. Sounds like you might benefit from trying to dry the filament out, check the web for more on that.

    After making sure the filament was dry and that my initial layer is good, because changing nozzles means you need to fine tune the z offset again, I would print a retraction tower test and dial in retraction length settings.

    That a good basic troubleshooting list.