Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then…

You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they’re apparently not in the ~/.config/cura folder anymore. Nice.

  • u_tamtam@programming.devEnglish
    3·
    9 months ago

    I’ve been on the prusa slicer side of things for a long time, and you won’t see me arguing in favor of cura. That said, you should probably consider doing daily backups of your home folder, using something like Borg/restic which have great incremental and compressed backups (practically backing up TBs in seconds).

    • fmstrat@lemmy.nowsci.comOPEnglish
      2·
      9 months ago

      Thanks, but everything is in my dotfiles repo, it’s just that cura ignores the files from the old version.