Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then…

You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they’re apparently not in the ~/.config/cura folder anymore. Nice.

    • fmstrat@lemmy.nowsci.comOPEnglish
      21·
      9 months ago

      The problem isn’t backups. The files are there and in my dotfiles repo. The problem is Cura decided to ignore the version 0.0 folder in 5.x, which is used in 4.x, and the profiles are no longer compatible. During upgrade, it doesn’t pull those files and convert. To me, this is a major oversight for something where tweaking profiles is a huge part of the quality of the output.