It’s really comforting to be in the hands of such an expert, I feel like you could teach me a lot. Everything is certainly turned on now, so tell me more about mounting
(Oh yeah, I’m not fucking with electricity at all, no worries there)
So if I’m understanding correctly - remember, I’m still learning, and I am an eager student - you insert your drive into my back port and then you load into my internal drive, and then everything works? Sounds good, when can we start?
Well, this crack allows me to increase the padding around the buttons up top, allowing easier handling. My drive however will likely be neither hard nor solid, but probably floppy.
The code that needs to be injected for this to work needs official approval first, though.
OK, I’m not white knighting here… but I don’t want to see you become the butt of the joke.
All of this double and triple entendre is getting out of control. For all of this back loading to properly work you need a proper tower case. Personally I’m into cases by the Eiffel company.
Eiffel towers are the best! You can front load AND back load simultaneously (some hand holding for structural support may be necessary). I utilize a method that has been widely recognized as the best. You have the comedic effect of a Spit Take along side the slow burn of a good Roast over how sloppy you com ports are. The colloquial term is SpitRoasting… it’s quite the undertaking but if we all work hard we can make this all come together.
Oh, I always make sure to turn it into a job for two people. Makes it easier to reach all the important spots when you have a helping hand.
However, make sure to follow my lead, your hands need to go exactly where I tell you to put them.
(Jokes aside for a second, never reach into an open power supply unless you know what you’re doing. In fact, best to not open it in the first place.)
So, now that everything is turned on, let’s go over how to mount a drive
It’s really comforting to be in the hands of such an expert, I feel like you could teach me a lot. Everything is certainly turned on now, so tell me more about mounting
(Oh yeah, I’m not fucking with electricity at all, no worries there)
Actually, mounting should happen automatically when you insert a drive into the back port. And then you can load your files to the internal drive
So if I’m understanding correctly - remember, I’m still learning, and I am an eager student - you insert your drive into my back port and then you load into my internal drive, and then everything works? Sounds good, when can we start?
We can start whenever you want, my system is never microsoft
I’m not opposed to Microsoft if that’s the way people choose to live their life, but I will follow your lead
Actually, it might not get hard anymore once I get my hands on this new firmware crack
Hey, we can work around that. Tell me more about this firmware crack though, I certainly am interested in modifying my hardware
Well, this crack allows me to increase the padding around the buttons up top, allowing easier handling. My drive however will likely be neither hard nor solid, but probably floppy.
The code that needs to be injected for this to work needs official approval first, though.
OK, I’m not white knighting here… but I don’t want to see you become the butt of the joke. All of this double and triple entendre is getting out of control. For all of this back loading to properly work you need a proper tower case. Personally I’m into cases by the Eiffel company. Eiffel towers are the best! You can front load AND back load simultaneously (some hand holding for structural support may be necessary). I utilize a method that has been widely recognized as the best. You have the comedic effect of a Spit Take along side the slow burn of a good Roast over how sloppy you com ports are. The colloquial term is SpitRoasting… it’s quite the undertaking but if we all work hard we can make this all come together.
That sounds like it becomes confusing and possibly messy, but I’m not not into it