Been ‘wet shaving’ since I started shaving a very long time ago and never stopped. When the blade slots went away in the back of the medicine cabinets in every bathroom, I made a blade bank from a steel can with a lid that I cut a slot in. I takes me years to fill it.
***For those too young to have seen it.
The medicine cabinet in every bathroom used to have a slot in the back of it to drop used razor blades into when they got dull. The would simply fall in between the studs in the wall and pretty much just rust away since the blade back then were made of plain high carbon steel. I remember helping to do several bathroom remodels and when pulling the cabinet and the plaster and lath wall, we would find a small pile of rusted to nearly dust razor blades.
I replied to another comment with the same question that I have never encountered this packaging. I get a cardboard box. Sometimes the blades inside are subdivided into little plastic capsules of five, sometimes they’re just stacked in the box. But that slot is entirely new to me.
I thought thats what’s you’re supposed to do. Wrap the blade in the wax wrap it came in, then break it up by bending it in the wax before throwing it away in the trash (still in the wax).
I’m not suggesting burning all trash, I’m suggesting burning a miniscule amount of steel to avoid the risk it poses to human and animal life. It turns into iron oxide (RUST). The fire pit ring itself will have about 100x as much of it.
I literally don’t have sharps disposal available to me. The rust will mix with the ash and become dispersed harmlessly into the soil. Look at an iron ore mine and you will see millions of tons of iron oxide, because that’s how iron is usually found in nature.
I use those blades in present day.
When I put in a new blade, I keep the wax paper wrapper, then rewrap the discarded blade in said wax paper before discarding it.
Give or take twelve years into this endeavor, I’ve had zero issues with this system.
Been ‘wet shaving’ since I started shaving a very long time ago and never stopped. When the blade slots went away in the back of the medicine cabinets in every bathroom, I made a blade bank from a steel can with a lid that I cut a slot in. I takes me years to fill it.
***For those too young to have seen it. The medicine cabinet in every bathroom used to have a slot in the back of it to drop used razor blades into when they got dull. The would simply fall in between the studs in the wall and pretty much just rust away since the blade back then were made of plain high carbon steel. I remember helping to do several bathroom remodels and when pulling the cabinet and the plaster and lath wall, we would find a small pile of rusted to nearly dust razor blades.
I also use a can.
I try to remember to use the old paper, but usually I despose of them in a cardboard toilet paper roll with one end pinched shut.
That’s a good idea also!
Why not just use the new wrapper for the old blade? That way you don’t need to keep the wrapper until you throw the blade away
What are you going to wrap the last blade in if you forget to buy new ones?
Painter’s tape.
Why wrap it until you’ve bought new blades? Unless you’re planning to stop shaving for years, in which case the blade might rust.
Just keep it in the razor, you can’t change it anyway.
This is where that saying “one is none” comes in. Have enough blades. Buy more well before you run out
That’s what I do. I suppose I didn’t articulate that well.
I do it a little bit differently in keeping the very first wrapper so that when I get to the very last blade, there’s a wrapper to put it in.
Minute variations, same end results.
If you don’t replace a blade until you have a replacement blade, why not just presume you’ll shave forever and use the wrapper from the next?
I did stop shaving for years and when I went back to shaving and replaced the old blade, and wrapped it in the replacement blade’s wrapper
why not return it to a slot on pakaging? isn’t it there for that purpose?
front:
and back
I replied to another comment with the same question that I have never encountered this packaging. I get a cardboard box. Sometimes the blades inside are subdivided into little plastic capsules of five, sometimes they’re just stacked in the box. But that slot is entirely new to me.
Sorry missed that one,.
My contry is just on the beggining of environmental awakening so most stuff is plastic packaging.
i just got these exact razors in the UK, but some blades such as Astras come in cardboard packaging
Ooh,
yea we’re few decades behind on environmental stuff here south.
Those are my favorite blades
That sort of packaging is only on the blades that are more expensive than the blades the price conscious commenters have been quoting the cost of
I have Dorco Prime blades that come in that kind of packaging. It was $11 for a pack of 100.
Because the blades I get aren’t packaged this way. Is that a reusable outer package? I’ve never seen anything like that.
Hi,
Actually these are standard, run of the mill, cheapest ones.
Wilkinson is like budget alternative to glide in safety razor category, You can usually get this packaging with this cheap plastic handle:
Wilkinson Sword Blades Classic
Classic Double Edge Razor Blades
I thought thats what’s you’re supposed to do. Wrap the blade in the wax wrap it came in, then break it up by bending it in the wax before throwing it away in the trash (still in the wax).
The little boxes they come in usually come with a little slot to dispose of the old razors. I just put the used and unwrapped razors into that.
I have not encountered such packaging. What brand do you use?
I usually buy Feather but I’ve seen it on plenty of other brands!
Winkinson pack has one too.
I just put mine in an empty tin. It’ll take forever to fill it up, and once you do, just tape it up and put it in metal recycling.
I put all my used ones in a clear pill bottle. Plan is to burn them in the next campfire I have so that they never enter the waste stream.
deleted by creator
You’re joking, right?
Why would I be joking? Razor blades will oxidize into nothing in a fire
That’s brilliant! We should burn all of our garbage so nothing enters the environment!
I’m not suggesting burning all trash, I’m suggesting burning a miniscule amount of steel to avoid the risk it poses to human and animal life. It turns into iron oxide (RUST). The fire pit ring itself will have about 100x as much of it.
Sharps disposal literally exists for this reason
Steel would also office without fire
Where do you think the rust goes in either case?
I literally don’t have sharps disposal available to me. The rust will mix with the ash and become dispersed harmlessly into the soil. Look at an iron ore mine and you will see millions of tons of iron oxide, because that’s how iron is usually found in nature.
Again, what do you think would happen if you didn’t burn it? It turns into super-steel?