Ordinarily, I wouldn’t turn down bacon for any reason, but in PLA it looks kinda bad. Any ideas as to cause and, more importantly, prevention?

Image

  • boothin@kbin.social
    link
    fedilink
    arrow-up
    5
    ·
    1 year ago

    It’s a little hard to tell from your photos but it looks like your nozzle might be too close to the bed. The first layer looks thin in places and the baconing could be from the plastic being squeezed out the sides

    • Mechanismatic@lemmy.ml
      link
      fedilink
      arrow-up
      4
      ·
      1 year ago

      Yeah, it can be useful to run a large 1st layer print (usually a test print) and live adjust the z axis as it’s pouring the icing to get the best lines.

  • cobn@lemmy.dbzer0.com
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    Over extrusion and first layer to close to bed.

    Adjust z oddest 0.05mm and see if it still happens. You might also calibrate your e steps if you still see issues.