It’s a new 2bay desktop TS-264. QNAP’s recommended operating temp is 0-40°C (32-104°F).

Am I taking a risk running close to 40°C; it could get that high if furnace runs for a long time. Are the temp swings a problem (it’s generally cooler than the rest of the house down there when furnace is off).

Any advice, tips, experiences please?

  • Spooler32@alien.topBEnglish
    1·
    10 months ago

    If your ambient temperature is that close to your operating temperature, you’re going to have to pass a hilarious amount of air across the machine to keep it within range. So don’t do it unless you’re going to blow fans directly at it that are controlled by internal thermostat or are always moving air fast enough.

    Not that this is hard. One 6"inline duct blower could do this if you cowl it right.

  • walden@sub.wetshaving.socialEnglish
    1·
    10 months ago

    My home server is located in our boiler room which sees similar temps. No problems, and the drive temps aren’t too bad.

  • seanho00@alien.topBEnglish
    1·
    10 months ago

    Provide it with conditioned air for intake, but in the cooling season route the exhaust to your furnace’s air return, to contribute toward heating the house.

  • RedSquirrelFtw@alien.topBEnglish
    1·
    10 months ago

    I’d consider insulating the ductwork and doing air sealing if it gets that hot, as it means lot of your heat is not making it where it should so your hvac is probably running more than it needs to.

  • Hexnite657@alien.topBEnglish
    1·
    10 months ago

    86 isn’t very hot, mines in my garage and in the summer it gets close to 110 in there. Servers, nas and network gear all fine and it’s been 4 years.