Hello,

I’m currently building a new house (EU). I’m planning to put ESP32 sensors in every room (top corner) with mmWave sensor to have a reliable presence detection.

I don’t know what the best way to power the esp32 is? Wi-Fi coverage should be good enough, so Ethernet is a plus but not mandatory.

POE looks nice but might require a bigger box as ESP32 with Ethernet looks bigger? Also, I’m not sure it will be able to power the mmWave sensor? I only saw 3.3V output. Any recommendations?

5V run from a central location (garage) might be difficult with voltage drop. Any recommendations for some cable specs and maybe experiences?

Last option would be a regular 230V run with 230V/5V transformer next to each ESP32, which also leads to a bigger box.

What do you think would be the best option?

Thank you for your advice!

  • rsachs57@alien.topBEnglish
    3·
    10 months ago

    One option might be a POE to 12/9/5v convertor like this. I use one to run a 12v non-POE switch up in my attic from a basement POE switch.