Title says it all. Most of the stuff I had no backup for. It sucks but I’m trying to take it in stride. Time will tell if I actually needed any of that data or if I was just hoarding it with no actual use.

I’m still trying to recover the data with pros, and in any case I’ll find a cost-efficient way to keep backups from now (any suggestions? One drive? External SSD?)

Have any of you experienced this? How do you feel or how would you feel? Is this your worst nightmare? Let’s discuss

  • WhatAGoodDoggy@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    I’ve had one drive die on me and that was in a PC that was inside my house when it experienced a severe fire.

    It lasted long enough for me to pull the data to another disk but on the next reboot it died.

    These days I have a parity protected nas, a backup nas and and an off-site storage solution with my more essential data. Also cloud for photos.

  • hobbyhacker@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    Why people only post here after their drive dies? Don’t be offended if you won’t get sympathy here, because there are about 2 posts like this every week.

    Why there are no posts like “Look, guys I’ve made backups, be proud of me!” ?

  • Odd_Medicine_4185@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    Have you tried contacting HARRY_SPEEF On Instagram? he’s the expert that helped me when i had same issue some weeks back

  • ByWillAlone@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    Depends on what caused the hdd to fail. If it was the PCB, for example - that would have been 100% recoverable 20 years ago, but for the past couple decades the interleave/alignment data is stored on the pcb and without the original, a drive just looks blank to a new PCB. If the drive supported on-device encryption, and the pcb failed, you can eventually put the drive back in service but your data is gone.

    Motors, bearings, and head actuators can usually be repaired enough to salvage data in a competent lab. Also certain failures caused by firmware flaws can be recovered from (I have done this myself).

  • lkeels@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    If you didn’t have a backup, you already know, it wasn’t important.

    • M3M3-@alien.topOPB
      link
      fedilink
      English
      arrow-up
      1
      ·
      10 months ago

      I guess not. Is anything that important? Is it not better to let go of as much as possible?

      • lkeels@alien.topB
        link
        fedilink
        English
        arrow-up
        1
        ·
        10 months ago

        The stuff on my drives is absolutely that important, and I have backups of all of it.

  • snatch1e@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    That is why you want to have backups. You have learnt it the hard way, you obviously not the one who had this issue. I believe almost everyone in a such way got his lesson.

    The most cost-efficient backups are still depending on the amount of storage. As for me, it can be external drive/backup NAS and cloud.

  • PintLasher@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    Don’t forget to unplug hard drives when they aren’t in use, helps them last a little longer. Also I heard cooling can make a difference. Almost time to replace my 2019 drives I think

  • Nobiting@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    Does anyone have any suggestions for offsite backup? I’ve heard backblaze is good but looking for suggestions!

  • Celcius_87@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    10 months ago

    Once as a teenager I think I had a drive die and I lost my data, but ever since then I’ve always made sure to have a backup of my data. Ironically, I haven’t had a drive die since then lol. For example, I’ve got ssds from over a decade ago still running daily with no issues.

      • Mossheart@lemmy.ca
        link
        fedilink
        English
        arrow-up
        1
        ·
        10 months ago

        All storage media fails HDD or SSD. Focus on a backup plan, not your media type.

      • Firestarter321@alien.topB
        link
        fedilink
        English
        arrow-up
        1
        ·
        10 months ago

        All drives die eventually whether they are HDD’s or SSD’s.

        8 years is a good run for any type of drive.

        Backups are key for keeping your data safe over the decades.

        • yogopig@alien.topB
          link
          fedilink
          English
          arrow-up
          1
          ·
          10 months ago

          But aren’t SSD’s good for like decades of continual use and petabytes of written data? That seems much more reliable than hdds.

          • Firestarter321@alien.topB
            link
            fedilink
            English
            arrow-up
            1
            ·
            10 months ago

            Not necessarily. I’ve had enterprise SSD’s die that were under 1yr old with less than 100TB written.

            I also have HDD’s used in my surveillance system that have several petabytes written to them over the last 6yrs still going strong.

            I just moved the HDD I got in my first NAS (8TB WD Red) to its 4th home and it just turned 7 y/o.

  • Mossheart@lemmy.ca
    link
    fedilink
    English
    arrow-up
    1
    ·
    edit-2
    10 months ago

    ‘There’s two kinds of people in this world, those that have backups, and those who will’

    Welcome to the club, and sorry for your loss.

    There’s lots of practices around backups with different levels of complexity and costs. Before deciding on how you want to handle things going forward ask yourself a few questions

    1. How important is this data? Is it irreplaceable?
    2. How much data do I have to backup?
    3. How do I want to control it? Locally? Cloud services?
    4. What budget do I have to do this with?

    In some cases, it’s cheaper and less headache to use cloud backup services for smaller amounts of data, with the downside being that you’re trusting someone else with your data.

    In others, setting up your own DAS(direct attached storage) or NAS (network attached storage) might make sense, then you manage the data locally. You should do some reading to understand the basic concepts of RAIDs 1,0,5 and 10 and how they affect data redundancy.

    Lastly, consider if a 3-2-1 (The 3-2-1 rule states that you should have 3 copies of your data (your production data and 2 backup copies) on two different storage types with one copy off-site for disaster recovery.) back up policy makes sense for you and your risk tolerance. Some absolutists will state you have no real backup without it, but IMO there’s some grey area there depending on different needs and risk tolerances.

    The important part is you’re now considering options to reduce your chances of experiencing this again.