I have a larger (100+ points) older xcomfort installation at home and I am looking to replace it.

Likely going with a combination of z wave and WiFi devices, controlled by homey.

However, I have a problem with some devices in the basement where connectivity is poor. However, I have called ethernet there.

So my question is, are there good ways to connect an ethernet connected relay which are cost effective and is there such a thing?

The alternative I am considering is stretching a cable from where the relays are and into a better coverage zone.

  • Z-Waver@alien.topBEnglish
    1·
    10 months ago

    Homeseer has what they call ZNet, additional hub like devices that connect back to the main controller, that address this issue well. The ZNet works with Homeseer and HomeAssistant, but I don’t know if it works with others. Perhaps Homey has something similar?