Hello!

I just got a Seagate Exos Mach2 dual actuator sata drive and am trying to create a RAID 0 out of the two halved partitions in order to mimic what the SAS version does with the two LUNs and basically double the potential speed by using both actuators simultaneously.

I cannot however seem to figure out how to create this striped volume, as the disk management options are all greyed out. I’ve tried switching the disk to dynamic as well, and it’s the same thing.

I’m not too sure how to achieve this, since RAID usually requires disks and not partitions, but it’s definitely achievable under Linux: https://forum.level1techs.com/t/how-to-zfs-on-dual-actuator-mach2-drives-from-seagate-without-worry/197067

Anyone know? The limitation being of course, Windows.

  • Asskunt@alien.topBEnglish
    1·
    10 months ago

    Did you do anything special after installing WinMD? I was able to create an array in Linux (with NTFS) and verify the speeds there – it was 1.8x-ish faster – but it’s not recognized in Windows after installing WinMD. I just get “WinMD controller” in device manager but no volumes show up.