I was hoping for a better inaugural Discuss post, but…

So, I got a Rebelle Jolt clone for Kiddo 02 because 01 liked theirs so much. So I thought I’d do the usual stuff like drilling out the air restrictor.

Except this time around, performance has gone way down. Barely flops out of the barrel. I thought I’d try replacing it with some brass (17/32 I think? I should really write this down), but it’s even worse now. I’m thinking of drilling out enough space for a Crayola barrel, but I’m kind of afraid I’m just butchering it at this point.

Please advise, and thanks in advance.

    • FrazzlusMaximus@discuss.onlineOP
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      I don’t think there’s any debris. A little bit of air restrictor I can’t quite get out, but it’s shoved out of the way just by putting a dart in. I added some silicone grease for good measure, so it’s all lubed up. And the sealing ring is stock, which worked fine before.

      • Ali@discuss.online
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        I’m betting that bit of AR that gets pushed back is misaligned and ends up blocking the connector between the plunger and the barrel. Jolts have this little ‘neck’ of tubing between the two, and it’s very small. You might want to get back in there with a pair of needlenose pliers or something.

        • FrazzlusMaximus@discuss.onlineOP
          link
          fedilink
          English
          arrow-up
          3
          ·
          1 year ago

          Okay, I think I got it. Because the stupid thing spins around when you try drilling from the front, I had to drill through the plunger tube. Thought I was going to shoot through the back of the barrel for a minute.

          Now not only does it work, but it kinda takes off now. I don’t own a chronograph, so I just go by the Whoa Test, i.e. I shoot it and go “whoa, that looks fast!”