I have a SanDisk 256GB extreme pro SD card for my camera. It works perfectly fine with the camera and with windows, but when I instert it into the card reader on linux (fedora 38) I can’t copy any files from it:

cp: Fehler beim Lesen von ‘…/DCIM/112_FUJI/DSCF2001.RAF’: Eingabe-/Ausgabefehler

Loosely translated:

cp: error while reading from ‘…/DCIM//112_FUJI/DSCF2001.RAF’: input/output error

the card is automatically mounted and shows up in the file explorer.

The fdisk command return this:

Festplatte /dev/sdg1: 238,27 GiB, 255835766784 Bytes, 499679232 Sektoren
Einheiten: Sektoren von 1 * 512 = 512 Bytes
Sektorgröße (logisch/physikalisch): 512 Bytes / 512 Bytes
E/A-Größe (minimal/optimal): 512 Bytes / 512 Bytes
Festplattenbezeichnungstyp: dos
Festplattenbezeichner: 0xf4f4f4f4

Gerät       Boot     Anfang       Ende   Sektoren Größe Kn Typ
/dev/sdg1p1      4109694196 8219388391 4109694196  1,9T f4 SpeedStor
/dev/sdg1p2      4109694196 8219388391 4109694196  1,9T f4 SpeedStor
/dev/sdg1p3      4109694196 8219388391 4109694196  1,9T f4 SpeedStor
/dev/sdg1p4      4109694196 8219388391 4109694196  1,9T f4 SpeedStor

I tried following this: https://www.reddit.com/r/raspberry_pi/comments/habv0q/fixing_linux_sd_card_reader_issues_inputoutput/
but it didn’t change anything

Does anyone have any idea?

EDIT:
I used the wrong fdisk command. I used /dev/sdg1 as opposed to /dev/sdg which is the actual drive. Here is the output of fdisk -l /dev/sdg:

Festplatte /dev/sdg: 238,3 GiB, 255869321216 Bytes, 499744768 Sektoren
Festplattenmodell: STORAGE DEVICE  
Einheiten: Sektoren von 1 * 512 = 512 Bytes
Sektorgröße (logisch/physikalisch): 512 Bytes / 512 Bytes
E/A-Größe (minimal/optimal): 512 Bytes / 512 Bytes
Festplattenbezeichnungstyp: dos
Festplattenbezeichner: 0x00000000

Gerät      Boot Anfang      Ende  Sektoren  Größe Kn Typ
/dev/sdg1  *     65536 499744767 499679232 238,3G  7 HPFS/NTFS/exFAT
  • Ramin Honary@lemmy.ml
    31·
    9 months ago

    Is your Linux laptop dual-booting Windows? I am wondering if you are using the same SD-Card reader to read the card on both Windows and Linux?

    This is relevant because if your Linux laptop is different it could be a problem with the SD-Card reader on your Linux machine.

    Assuming your card reader works fine on Windows but not Linux, it is probably a driver issue. Linux is clearly reading the SD-Card boot sector since it is reporting information about the partitions. But if it is a hardware issue (not likely if it is working on Windows with the same card reader), it may start to read the card and then fail as soon as it starts to draw too much power or heat the card up or something.