Not really, I just kind of wing it, honestly. I’d recommend printing in white or gray to begin with, but after that I just go for it. I figure if I completely screw it all up, I can just print another and start again, lol. I’m not an experienced painter by any means, but I enjoy it when I do. It’s very relaxing to just throw on a podcast and zone out for a while.
I’ve printed a few minis but have no idea where to start in regards to painting them - got any good resources to share?
Not really, I just kind of wing it, honestly. I’d recommend printing in white or gray to begin with, but after that I just go for it. I figure if I completely screw it all up, I can just print another and start again, lol. I’m not an experienced painter by any means, but I enjoy it when I do. It’s very relaxing to just throw on a podcast and zone out for a while.