Jokes on you. I’m a Machinist and that feature on the drawing has an perpendicularity GD&T callout of ± 1deg. In spec is in spec. Ship it!!!
It’s 87 degrees
No, no- it’s the design engineer who is clearly wrong.
Nah I blame the mathematicians
I like this positive attitude!
Full send
As long as it’s perfectly 89° it’s fine. That’s acute angle.
It’s very well drawn too, no overshooting on the edges. Looks good to me.
It’s 87
Barely acute 😳
Engineers: Eh, close enough.
shrugs Same order of magnitude
Guys it’s actually 90° but the photo is taken on an angle.
I didn’t know 1° difference would be this noticeable. I am very disturbed.
It’s noticable cos its 87 degrees not 89.
More concerned about why you wasted all those colors on this image when two was sufficient?
Ahhh, I love it when the 89 degree angles are perfectly 89 degrees.
I’ll see you in hell
deleted by creator
You should have put the little square thing in the corner to indicate a right angle!
It’s still perfect since you can just take 32040 of these (= 89*360, ggt is 1 since 89 is prime) and then you will have a full circle. A real shame it would have been when you would have took an irrational amount of degrees since then this calculation would not be possible. There could only be an approximation that makes it impossible in reality to decide if it is right or not but mathematically speaken it would be impossible.
I can’t believe you’ve done this
Wish i didn’t see this
Anybody who posts images like this have a special position in hell
That’s not right.
You evil son of a witch.
