I have an indoor/outdoor thermometer to keep track of how hot the back of my Expedition gets. I drive pretty regularly with two dogs in the back, and over the summer and winter the temps can get a little extreme.
I need to be able to take it out to keep an eye on it remotely (it has about 1/4 mile range) but also have it not rolling around while I drive.
There was a coin holder there that I popped out, and used as a template for an insert to keep this mounted semi-permanently.
Printed with kinda crappy Amazon Basics PETG. If it holds up well, I’ll reprint it with better quality black PETG so it matches the car better.
I think I bought a spool of PETG a while back. I know I have two spools of ABS that I haven’t touched yet, but that was very much for a reason. I’ll be near micro center this weekend so I’ll have to dig through my box of filament before then.