Basically, I have an extender for the garden but whenever I go to the garden, my phone remains connected to the extender when I’m back in the house and I can always tell because everything is always slower to load when connecting through it.
How can I make my devices strongly prefer to connect to one SSID when both are there?
Are they both using the same SSID or sperate?
If you search your phone for wifi priority you can set a preference.
If the same SSID, it should automatically swap to the highest connection strength AP. Depending on the networking hardware you might beable to addjust single strength. They could be overlapping, and reducing singal overlap may help the phone determine what AP it wants a bit easier.
Agree with reducing power. A common mistake when using multiple access points is to set them all to full power.
Devices usually don’t constantly look for a better signal, instead they look for alternatives once the current connection quality is bad. Some devices will hold on for dear life until it’s borderline unusable.
Unless you’re looking for redundancy, the best case scenario is to have only one good option in every area of your home. That’s not always possible, especially where they overlap, but the closer you can get to that ideal, the more likely it is that your device will make the switch.
You should also be able to adjust the backhaul power separately, so you don’t have connectivity issues between the extender and router.
There’s also the WiFi roaming sensitivity settings that I know at least Intel adapters have. I recall it being on the client side, but I’m definitely no expert.
Thanks for expanding on the knowledge. I was mainly speculating a bunch of stuff seeing limited information of the setup was provided. You explained that much better than myself.
You can try and see if Tasker can turn Wi-Fi off and then back on when your extender’s Wi-Fi signal is low.
I used to do this before switching to a mesh Wi-Fi setup.