I have do some research about doing dactyl manuform, and I see people mostly solder directly diodes and copper wire to the switch. So i want to know that if i build dactyl manuform with hotswap function, will there have some problems which can kill my board? And when comparing handwired and hotswap. which is easier to do if i’m a beginner? And another question: is reset buttons neccessary for this build? (because i saw many guides are always including this component)

  • ffhein@lemmy.world
    link
    fedilink
    arrow-up
    2
    ·
    1 year ago

    Regarding the reset button, depending on how your firmware is configured it might be necessary for flashing they keyboard. It seems like most firmwares have keyboard combos for flashing without a reset button though, see this.

    • Necromnomicon@lemmy.world
      link
      fedilink
      arrow-up
      1
      ·
      1 year ago

      I have a dactyl manuform and for the life of me cannot get any of the keyboard commands to actually reset the board. So I have a reset switch on mine for that reason.

        • Necromnomicon@lemmy.world
          link
          fedilink
          arrow-up
          1
          ·
          1 year ago

          QMK. I dunno what the issue is, but the reset button took care of it, so I never really bothered to look into it after that.