A joint study between Yale University, King’s College Hospital in London and Doctors Without Borders found a single shot could be made for just 89 cents.
Im not in charge of the checkbook, but I do place purchase requests. I also am in charge of reducing direct labor and know what our overhead numbers are. We are a small company though. It should be possible to reduce overhead in larger companies due to economies of scale, however, it is not always the case as the bureaucracies required to interface with the FDA are not trivial.
I was involved with a product transfer for a large company one time. Due to the small volume of the product and the complexity of Sustaining and reporting activities it had a 60% overhead. I did look at the books on that. While that’s an extreme case, I’ve also seen product launched with 40% yield. One device I worked on was a stapler for the heart. We had to load the tiny staples into the device, fire it, evaluate the staple formation, then reset and reload the staples. It had about 80-90% yield if I remember correctly.
These aren’t roast beef sandwiches. People die if you fuck up.
…and you are shit-canning someone else’s input because they don’t know everything based on your even more limited experience, suspect knowledge, and a heavily biased opinion of how you think the world should work. Lay out your superior knowledge or admit you’re just spewing a party line for the upvotes because it sure sounds like they know a hell of a lot more about the subject than you do.
Im not in charge of the checkbook, but I do place purchase requests. I also am in charge of reducing direct labor and know what our overhead numbers are. We are a small company though. It should be possible to reduce overhead in larger companies due to economies of scale, however, it is not always the case as the bureaucracies required to interface with the FDA are not trivial.
I was involved with a product transfer for a large company one time. Due to the small volume of the product and the complexity of Sustaining and reporting activities it had a 60% overhead. I did look at the books on that. While that’s an extreme case, I’ve also seen product launched with 40% yield. One device I worked on was a stapler for the heart. We had to load the tiny staples into the device, fire it, evaluate the staple formation, then reset and reload the staples. It had about 80-90% yield if I remember correctly.
These aren’t roast beef sandwiches. People die if you fuck up.
Removed by mod
…and you are shit-canning someone else’s input because they don’t know everything based on your even more limited experience, suspect knowledge, and a heavily biased opinion of how you think the world should work. Lay out your superior knowledge or admit you’re just spewing a party line for the upvotes because it sure sounds like they know a hell of a lot more about the subject than you do.
Them:
You:
Well done.