- cross-posted to:
- lasercutting@lemm.ee
- cross-posted to:
- lasercutting@lemm.ee
I had an open wall and a sheet of cheap 3/4inch plywood sitting around so I made a French cleat wall.
If you are not familiar with the system, the slats on the wall have the top edge cut at a 45 degree angle and the shelving/storage items have an opposite angle so they slide right into the grooves.
More pics of my messy shop
You must log in or register to comment.
Inspiring! I also have some plywood lying around and some walls…
Get to it!
Oh, to be a homeowner…
I guess if you include my house in the price of the French cleat wall it’s not so cheap.
I have been planning (but not yet implemented) a wall for my workbench area. I’m hoping to make holders for my most used tools and a few of the larger pieces that don’t fit in the cupboards.
Very nice! Wish I had the space for one myself.
I’m really loving how this turned out for you. Great job!
Thanks
Did you use a table saw for the 45s?
Yes, I used my table saw.
However with a diy circular saw sled you could do this without too much fuss. Most circular saws I have seen allow the plate to be adjusted so the blade sits at an angle so that shouldnt be a problem.
I have broken down plywood into strips in similar fashion using that method.
Simple version https://www.wwgoa.com/article/shop-made-circular-saw-guide-cheap-easy-and-awesome/
If you have access to a router you can make a version that keeps you from straying https://www.woodmagazine.com/saws/shop-made-circ-saw-guide-cant-stray
When I cut down sheet goods with a circular saw I have a big 4x8 piece of foam insulation I lay on the ground and then set the plywood on to keep things well supported and keep the blade from hitting the ground.
Very nice! I really need to do something like this myself.
