Anyone know what settings to change in Cura to help supports leave less markings on the print body?
You must log in or register to comment.
I’m not sure what orientation you’re printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you’re always going to have a rougher surface than printing without them
Also in this case it might make sense to split the model, then glue it together.
Here’s the top side for comparisonThere might not be a good way to escape support artifacts on the print surface for large, irregularly shaped prints. You can certainly try organic supports, but you might want to look into post-printing processes to improve the look and texture. It’s more work, but it might get the result you want.
