I don’t need anything too fancy, I just want to be able to watch the camera, and stop a print if it goes wrong.
Networking is all set on my end too. Got an OpenVPN tunnelback to my house for other stuff.

  • stealth_cookies@lemmy.caEnglish
    2·
    2 months ago

    Yup, you just need somewhere in your local network to install it. I’ve been using it on my P1S since I changed it to LAN only mode a couple weeks ago.

    • calmluck9349English
      1·
      2 months ago

      OctoEverywhere I have the service working. It loads fine on Octoeverywhere but the share link is not working on Octoapp

    • Uninvited Guest@lemmy.caEnglish
      1·
      2 months ago

      Do you use an AMS? I had my printer in LAN mode but found that I couldn’t synchronize custom filament profiles to the AMS without enabling cloud and logging in via orca.