Basic blender went bad (motor ran but spindle wasn’t rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn’t unscrew the fourth. It was a slotted spanner.

  • fraksken
    link
    fedilink
    arrow-up
    3
    ·
    6 months ago

    Take a flat screwdriver and moubt it on a vice. Take your angle grinder, mount a disk for metal grinding. Grind away the middle of the flat screwdriver head. Done it before for the exact same purpose.