There are no arrows, no obvious pins, no pin latches. This band is different than all of the ones I’ve ever sized. Does anyone know how to remove links from this band?

Edit: user Septimaeus was correct in that it was a fixed link band. The link they provided helped in understanding what is requires to resize, and the band now fits my wrist like it was made for it. Thanks!!

  • @Septimaeus
    link
    11
    edit-2
    4 months ago

    It looks nice! If it also keeps the time, I’d say it’s a good find. (If by true value you mean resale estimate, about $10-15.)

    It’s a good watch to tinker with, if you’d like to try. If your tools are limited or that’s too much hassle, many stylish and inexpensive replacement bands can be found online, even ones that look like the original. I’ll put brief instructions for that below.

    • @Septimaeus
      link
      7
      edit-2
      4 months ago

      If you’d like to replace the band, you can measure the lug width (e.g. 20mm) to find one that’s compatible. When you’re ready to swap the bands, you will find little spring bars beneath the lug joint covers.

      If it’s difficult to reach the spring bars through the gaps, you can loosen each cover by slightly bending the two tensioner arms on the underside of the watch.

      There are little notches on each side of the spring bar that you can catch with a small tool/knife/fingernail and compress, letting each side of the bracelet free.

      Installation of the new band is the reverse but usually easier, especially if your new bracelet style doesn’t use a shroud over the lugs.

      Then you’re done!

      (Also, if you want to put the joint shrouds back at some point, just remember to pinch the tensioner arms a bit before reinstalling, otherwise they will be noisy when you move your hand.)