An ice fishing box to house my ic-7000, an atu, a battery pack. Very crude but solid rack made of pine board I had laying around. This is cobbling of the best sort.

  • LB8EI@lemmy.radio
    cake
    OP
    link
    fedilink
    arrow-up
    2
    ·
    10 months ago

    A fan or two into that gap below the radio is one of the improvements on the block. Together with a voltmeter for the battery.

    • Jason - VE3MAL@lemmy.radio
      link
      fedilink
      arrow-up
      1
      ·
      10 months ago

      Put the volt-meter in series with a switch or momentary button. They tend to draw a little power, so you don’t want it draining your battery when you are not using it. If you stick a cig (accessory) port in there too, you could plug in other things, or a usb charger or whatever if needed. I’ve used my pota battery to run a small 12v air compressor, for instance.

      • LB8EI@lemmy.radio
        cake
        OP
        link
        fedilink
        arrow-up
        1
        ·
        10 months ago

        I have a master switch on the power cable before the fuses even. I lost a couple of expensive lipo batteries when I forgot to disconnect them and put the radios away for a few months.