This is the temp tower of my wood print experiment Cand even se much difference. It goes from 260 to 190. Below 225 gets really flimsy and above 240 melts. But even 230, the “best” one is really bad, and I’m not talking about retraction. Even the layers that melt are inconsistent.

Also it’s not humidity since the filament was in a filament dryer for.16hours.

edit: The nozzle is 0.8

can someone think of anything else?

  • NaibofTabr
    link
    fedilink
    English
    arrow-up
    17
    ·
    3 months ago

    Did you change the nozzle setting in your slicer to 0.8? They usually default to 0.4

    It definitely looks under extruded.